Marlec Eng Co Ltd Installation Instructions
__________________________________________________________________________________________
Document No: SM124 Issue D 30.01.07
9
Furlmatic Tail Assembly (Fig. 5)
1. Remove the cover from the main housing.
2. Remove the M6 nut, washers and bolt from the tail boom.
3. Insert the tail boom into the saddle on the underside front of the housing.
Ensure the tail assembly is the correct way up. (refer to pictures in this
manual & the text on the tail label).
4. Re-fit bolt washers & nut removed in 2, passing the bolt through the tail
boom and windshaft housing. Tighten all fasteners.
5. Replace cover.
Note: Do not remove the silicone protectors from the tail stops
!
Tail Boom
Fasteners
NB. The tail fin is set at an angle of 15°
from vertical. Check that the tail fin is
positioned as shown in the diagram (as
viewed from rear of the Windcharger)
Fig. 5
