Testing Your Installation
Ignition Key In Sensor
Switch Closes with Key
In Ignition Cylinder
To Hood Pin Switch Safety Shut Down
Safety
IN4003
White/Black Wire
(-) Negative Safety Input Wire
Black 7-Pin
Mini Connector
Method 2
To connect to the
Key-In
Sensor Circuit as shown for Method 2:
A. Locate the control wire that connects the driver’s door pin switch to the key-in sensor switch.
B. Cut this wire and connect the ignition cylinder side to chassis ground.
C. Locate the key-in sensor switch wire that connects the chime module to the ignition cylinder.
D. Cut this wire and connect the ignition cylinder side to the Remote Start Negative Safety Shut down wire
WHITE/BLACK, using a 4003 series diode as shown above.
Note: A second 4003 series diode may be required to maintain the integrity of the hood open, shut down circuit. If
this is the case, it must be installed as shown in the diagram above. The anode (Non Stripped) side must be
connect to the WHITE/BLACK wire of the Remote Start Unit. The cathode (Striped) side must be connected to the
hood pin switch.
AFTER THE CONNECTION OF THE NEUTRAL START SAFETY WIRE AS INDICATED IN ANY OF THE PREVIOUS
ALTERNATE CONFIGURATIONS, THIS CIRCUIT MUST BE TESTED FOR OPERATION. Retest by following the steps
outlined in NEUTRAL START SAFETY TEST shown in this manual.
27
M7A-IM 6/22/06 4:53 PM Page 27
