Voltage Detection Additional Programming
If you have selected Voltage Detection, you may be required to program 1 additional feature as enclosed.
Crank Detection Level Programming:
Turn the ignition switch from the
OFF position to the ON position 3
times leaving it in the Off position
the third time.
Step 1
Before 15 seconds has passed, push
and release the valet switch 9 times
then push the valet switch a tenth time
and hold it down until 5 short
chirps/beeps + 1 long chirp beep is
heard then release it.
9X + 1X (Hold)
Step 2
If all things seem correct, press the
(* - *) button to stop the engine
running. If a cranking problem is
noticed, move to Step 6 to adjust
the crank detection feature
otherwise follow Step 5 and get out
of the programming mode.
Step 4
Press the (* - *) button on the
transmitter to start the engine by remote.
Setting the crank detection to low should
have solved the over-cranking problem.
Note: Let engine run for 10 seconds
or more to ensure proper operation.
Press the (* - *) button on the
transmitter to start the vehicle. If
everything is correct, the engine will
crank and fire without over-running
or under-running the starter.
Note: Let engine run for 10 seconds
or more to ensure proper operation.
Press the (Lock) button on the
transmitter to get out of the
programming mode. You will hear 3
long chirps and get 3 parking light
flashes for confirmation.
If the engine shuts down after 10
seconds you may need to adjust the
crank detection level. Press the (Car)
button on the transmitter to change
the crank detection level from Hi to
Low. You will hear 1 chirp/beeps to
indicate the feature has been
changed to the low selection.
Step 7
Step 5
Step 6
Step 3
21
Press the (Lock) button on the
transmitter to get out of the
programming mode. You will hear 3
long chirps and get 3 parking light
flashes for confirmation.
Step 9
If the engine still cranks too long or
not long enough, you may need to
adjust the start timer. Press the
(Unlock) button on the transmitter
to change the start timer length as
shown in the chart (page 18). Follow
the chart and listen for the different
chirp count to select the time you
want to use.
Step 8
3X
M7A-IM 6/22/06 4:53 PM Page 21
