MARIMEX UNO 35, Instruction

Page: 15 / 20

15
for reclamation become void. In such a case producer and seller waive any and all
responsibility for incurred damages. Persons not familiarized with operation of
solar shower within this manual are not allowed to use this equipment. Because of
temperature inside shower body which may reach 60 - 70°C we recommend to turn
the lever valve first to right and firstly open cold water. And after that mix with hot
water to required water temperature by turning the lever valve to left. In this way
you avoid undesirable showering with hot water! If the shower is not used for some
time, also small amount of water can be heated in supply hose to valve. Due to safe
use it is necessary to let out small amount of water (approx. 3 seconds).
Assembly instructions
Place the solar shower at a place with sufficient sunlight and within reach of water
supply. Install solar shower vertically onto a firm and horizontal base. Ideally using
wall plugs onto a concrete foot, ceramic tile or eventually using long nails into the
earth. Screw the hose onto the shower armature opening at shower column front
part. Shower hose screwed connection is furnished with rubber sealing and on that
ground it must be tightened manually not using any tool. Suspend shower head
onto holder in shower body upper part.
In the bottom part of the shower column there is an opening of shower armature
(1/2“) for easy connection to water supply. Connect closed water supply to it. Once
water supply has been connected to the shower body, open the water supply pro-
vided the water pressure does not exceed 3 bars. After having connected the solar
shower to water supply, fill shower body tube fully with water and vent it at the
same time - by opening the filling valve and lover valve to hot water position and
let it opened completely until water starts to pour continuously from the shower
head. Then push the control lever to the position „Closed“. Solar shower is ready for
use. For connecting of solar shower armature to water supply or home water sys-
tem use only typified, approved and not damaged plumbing installation members.
In the end check tightness of armature connections.
Maintenance, winterising
The garden solar shower requires no special maintenance.
Keep the solar shower clean.
At the end of the season, completely disconnect the solar shower from the wa-
ter supply and drain all water from the body thoroughly. To drain the shower, it
must be removed from the solid surface and the shower side must be drained by
unscrewing the plug on the side (see FIGURE 1), with the lever mixer in the open
position between the hot and cold positions. After draining, there will be a residual
minimum amount of water in the shower due to its construction. This residual wa-
ter no longer causes damage to the shower. During storage, ensure that the lever
tap, shower rosette remains dry - wrap the lever tap and shower rosette tightly to
prevent moisture ingress.
Out of season in a dry, store the product in a frost-free place.
EN