Camera Disassembly
- 24 -
11.
CAMERA DISASSEMBLY
Camera Case Removal
1)
Remove the harness and the main part of the insulation muff.
2)
Disconnect the voltage stabiliser unit by unplugging the in-line
connector situated by the pistol grip.
3)
Hold the camera with the lens uppermost, depress the front
plate and rotate the breech ring clockwise to unlock the case.
4)
Remove the camera from its rear case.
5)
To replace, reverse the above procedure. Whenever possible a
new sealing ring should be fitted.
To Remove Front Plate, Lens Assembly and Tube
1)
Remove case as above.
2)
Remove internal R.F.Screen by desoldering front earth tag and
removing two screws on rear of chassis.
3)
With camera standing on its front, remove the four front retaining
screws taking care not to damage the shutter blade.
4)
Unplug P101 and carefully lift the camera chassis away from the
front.
5)
Remove the chassis front plate and lens assembly complete by
removing the four retaining screws (see diagram page 18).
6)
Loosen the tube clamp, remove the tube retaining ring on the
front of the yoke and carefully withdraw the tube from the yoke
whilst holding the tube base. Note the tube orientation for
replacement (see diagram page 17).
7)
Replace using the reverse of the above procedure taking care to
install the sealing gasket between the lens and the case front.
The dessicant container should be replaced with a new or
reconditioned part.
