StarLam 1600R User Manual
25
●
Sections in the middle and sides of
the material being coated seem to be
rubbed off in spots. The coating can be
seen going on as a wet film but does not
come out that way when coming out of the heater.
●
It is possible the heater box support tabs
have been damaged. Replace or repair box supports
before using machine again.
●
The heater box heat trap flap may be bent
or damaged. Replace or repair part as necessary
before using machine again.
●
The material being coated seems to coat with a
jerky motion somewhat resembles
a chattering motion.
●
Reduce some of the clutch friction to the core rod
where the material is being pulled from.
(Core rod on same side as main control console).
●
Apply some graphite powder to the clutches where the core
Contacts the clutch assembly.
●
Fluid flow from the main dispensing valve has
Started coming out slower. The fluid doesn't seem to
Keep the laminating area supplied.
●
One of the fluid connectors is blocked. Remove connector
And force water the opposite way through the connector or
replace connector.
●
Fluid valve is blocked and needs to be cleaned.
●
Fluid reservoir bottle needs to be refilled. Not enough
Head pressure.
●
Fluid Reservoir bottle is full but liquid is barely
dispensing out of fluid valve or has dropped out
completely.
●
Fluid reservoir needs to thoroughly cleaned and scrubbed to
remove dried laminate from the walls of the jug.
●
Flush Fluid connectors in the opposite of flow direction to
remove dried laminate chunks.
●
Machine heater temperature cannot be controlled
or adjusted.
●
Solid State Heater relay has gone bad and needs to be
Replaced. Contact Clearstar.
●
Liquid seems to run mostly to one side of the
coating rod and barely saturates the other side.
●
Machine needs to be leveled properly.
●
Metering rod is not rotating properly.
●
Rod is not seated correctly in the holding cradle.
●
Rod is not tightened down sufficiently to allow proper
friction between media and rod.
●
Heater is not getting hot enough when turned up.
●
Insure that the machine is getting the required voltage and
amperage.
●
Machine is coating but motion is jerky or
Chattering.
●
Too much tension is on the clutches holding the feed core.
●
A small amount of graphite powder lubricant needs to be used
On the clutches where the discs rub against each other and
Where the core goes onto the clutches.
●
●
●
●
●
●
●
●
●
●
