StarLam 1600R User Manual
22
4. Once the container is in place and the hose is hanging into it then open the laminate
trough drain valve.
5. Let the trough drain completely.
Preparation of machine before use:
1. Use 4 gallons of room temperature or warm water to fill the wash trough on the bottom
of the machine.
2. Hook up the cleaning hose to the wash hose connector on the machine. (Should be
located on the front of the machine just under the three valve switches)
3. Prime the wash hose by switching on the wash pump motor until a steady stream of
water is emitted at the end of the hose. Be sure to point the cleaning hose into the wash
trough. Once the hose is primed drape the hose so that the end is hanging over the wash
trough to avoid leaking water onto the floor.
4. Make sure the material to be coated is cored and fastened into the machine as
previously described in the manual.
Valve Functions:
To Perform:
Lamination
Siphon from
Drum with
Peristaltic Pump
Cleaning the
Liquid Laminate
Circuit of the
Machine
Valve 1 Position
Laminating
Laminating
Laminating
Valve 2 Position
Laminating
Cleaning
Laminating
Valve 3 Position
Laminating
Cleaning
Laminating
Lamination Procedure:
1. Make sure all three Valves are switched to the laminating position. (insert Picture)
2. Open the fluid reservoir valve.
3. Open the fluid dispensing valve.
