StarLam 1600R User Manual
14
Figure 11
▲
To ensure even film thickness and proper coating please stretch the material tightly and
evenly.
5.
The substrate must be spooled onto strait and without variance from side to side.
6.
Switch the main power supply to the on position. Next, switch the machine power
to the on position so that the power light illuminates. The fan in the heating box
should also begin rotation.
7.
Switch the power for the electric motor on so that the roll of printed media moves
forward slightly. Continue this movement until the webbing is stretched evenly
and tightly. Once this is achieved immediately stop the rotation of the machine.
▲
When the front end of the webbing moves forward the printed portion does not move pass
the metering rod to avoid incompletion of the lamination run.
8.
Make sure the heating box is in the raised position. Adjust the heater setting knob
on the main control console to the desired temperature position. Switch on the
heating power switch. The machine will begin preheating. At this moment it is
necessary to wait a few minutes for the heater to preheat.
9.
Adjust the fluid control valves on the liquid reservoir bottle and the nozzle end so
that liquid is injected onto the webbing (material to be coated). The nozzle should
be adjusted to be in the center of the area to be coated.
