56
Montage- und Betriebsanleitung
Installation and Operating Instructions
EN
The system for the coolant supply on tool holders to DIN ISO 7388 makes it possible to combine the common forms of cool-
ant supply into one machine-side tool body of FFoorrm
m AADD//AAFF.
The system makes it possible to combine the following designs:
•
FFoorrm
m AADD: Central coolant supply via through bore (normal setting)
•
FFoorrm
m AAFF: Central coolant supply via collar
To adjust the tool holder to the type of coolant supply on the machine, it is sufficient to adjust the position of two threaded
pins. The threaded pins (secured with thread locking compound) then seal off the bore for the alternative coolant supply.
WTE After-sales Service is also at your disposal for the changeover.
55..55..11
N
Noorrm
maall sseettttiinngg FFoorrm
m AADD oorr JJDD ttoo DDIIN
N IISSO
O 77338888
Unless otherwise indicated in the purchase order, the tool hold-
ers are delivered in FFoorrm
m AADD.
Normal setting of the coolant supply
Montage- und Betriebsanleitung
Installation and Operating Instructions
57
EN
55..55..22
CChhaannggee oovveerr ttoo FFoorrm
m AAFF oorr JJFF
Change over of the normal setting to coolant supply FFoorrm
m AAFF.
W
WAARRN
NIIN
NG
G
RRiisskk ooff bbuurrnnss ffrroom
m hhoott tthhrreeaaddeedd ppiinn aarreeaa!!
Serious burns and injuries can occur during heating and unscrewing the threaded pins.
Always wear ISO protective gloves when heating and unscrewing the threaded pins.
After heating, wait until the heated threaded pin area has cooled down.
Heat the threaded pins or the threaded pin area until the threaded pins
can be unscrewed.
W
WAARRN
NIIN
NG
G
RRiisskk ooff bbuurrnnss ffrroom
m hhoott tthhrreeaaddeedd ppiinn aarreeaa!!
Wear ISO protective gloves and wait until the threaded pin area has
cooled down.
Unscrew the threaded pins using an hex-wrench 2.5.
Remove the adhesive residues from the threaded pins and threaded bores.
Montage- und Betriebsanleitung
Installation and Operating Instructions
56
EN
