Mantracourt T24-AO1, Technical Manual

Page: 52 / 98

Mantracourt Electronics Limited
T24 Technical Manual
51
Parameter List
Parameter
Command
Number
Description
Native
Data
Type Read /
Write
ID 3 Read the unique identifier ID for this device. (3 bytes) BINARY 3
bytes R
Version 53 Read the firmware version. FLOAT R
Channel 11 Radio Channel UINT8 RW
EncKey 15 The radio encryption key to operate on. Requires
power cycle or Reset to enable.
Not supported in this
release.
BINARY
16 Bytes RW
Power 12 Set or read the output power level. (0-100%) UINT8 RW
Name 10 Set or read a user defined name. (11 characters) STRING
11 Bytes RW
Model 51 Read the model number of the device. STRING
11 Bytes R
UseCSMA 18 Select whether to use
Carrier Sense Multiple Access
techniques on transmission
.
Value Description
0 Disabled
The
Carrier Sense Multiple Access
will be
disabled. NOT RECOMMENDED
1 Enabled
The
Carrier Sense Multiple Access
will be
enabled.
See
Unslotted CSMA/CA
in
Appendix A
UINT8 RW
OffDelay 62 Time period in seconds before switching off if no
button is pressed. Setting to zero disables. Default = 5 UINT16 RW
AutoZero 63 Set or read the value limit which may be automatically
zeroed on startup.
When the handheld powers up and the input value is
within ±ZeroBand then the display will be zeroed. The
value of the input will be placed in AutoZero. i.e. from
this time onwards until powered off the display will
show
input value - AutoZero FLOAT RW
DoSleepWake 64 Set or read whether to perform wake and sleep on the
paired device when the handheld is powered up and
down. Default = 1 UINT8 RW
Timeout 65 Set or read the time in seconds that if exceeded
between receiving Data Provider packets from the
paired device will cause the display to show ------.
Default = 3 UINT16 RW
KeepAwakeInt 66 Set or read the interval in seconds between the
handheld transmitting
StayAwake signals to the paired
device. Default = 5
UINT16 RW
DisplayUpdate 74 Set or read the interval between LCD updates. Default
= 300 UINT16 RW
PairWait 67 Set or read the period in seconds that the handheld
will wait for another device to pair when placed into
pair mode. Default = 5 UINT8 RW
Format 70 Set or read the format for the display. Here you can
define how the value will be displayed and where the
decimal point will appear. By including a non zero
value this will define the resolution of the displayed
value. i.e. the smallest step size of value changes.
Default = 0000.001 STRING 8
bytes RW
ZeroSupp 71 Set or read whether to show the value on the display
with zero suppression.
0 = No zero suppression
1 = Zero suppression UINT8 RW