Mantracourt T24-AO1, Technical Manual

Page: 38 / 98

Mantracourt Electronics Limited
T24 Technical Manual
37
Note that default value is set to last 2 bytes of ID.
UserGain 79 Set the gain to apply to the input FLOAT RW
UserOffset 79 Set the offset to apply to the input FLOAT RW
RawValue 70 Read the raw uncalibrated input. FLOAT R
Value 72 Reads the user calibrated output. FLOAT R
IgnoreFirstPulse 82 Set to 1 to ignore the first pulse detected after power
up or wakeup UINT8 RW
PPR 83 Pulses per revolution. Indicates how many pulses the
input will receive per revolution when in RPM mode. (1
to 100) UINT8 RW
EdgeType 84 Select the input edge to trigger on
Value Definition
0 Falling
1 Rising
UINT8 RW
OutputType 85 Select the input edge to trigger on (0 to 3)
Value Definition
0 Frequency (Hz)
1 RPM
1 Interval (s)
1 Counter
UINT8 RW
InputFilter 109 Enter a time in milliseconds to act as a debounce
filter. Input pulses arriving within this time of the
previous input will be ignored. UINT16 RW
DigitalOut 108 Read or set the digital output state.
Value Definition
0 Turn digital output off
1 Turn digital output on
2 Make digital output mirror the LED
state (V1.05 and later)
FLOAT RW
Status 74 Live status where the bit values indicate status. The
following table shows the decimal bit values and their
meaning.
Bit Value Definition
1 STATUS_SHUNT_CAL
2 STATUS_INPUT_INTEGRITY
4 Reserved
8 Reserved
16 STATUS_POWER_UP
32 STATUS_BATT_LOW
64 STATUS_DIGITAL_INPUT
128 STATUS_DIGITAL_OUTPUT
Reset 54 Restarts the device and utilises new channel and
encryption keys if those have been changed and saved. Command
Save 55 Save any changes made to parameters. Required
before power cycling or issuing a Reset command.
Requires 500mS recovery time after executing. Command
Wake 50 Wake the module from sleep Command
Sleep 56 Sends the module to Sleep Command
Pause 57 Stops the output streaming to allow configuration Command
Resume 59 Streaming continues. Command
StayAwake 58 No function other than to reset SleepDelay timer Command
ResetCounter 64 No function other than to reset the counter when in
counter mode Command
ResetTrigger 118 Enter Data Tag to watch for that will reset the counter
when in count mode UINT16 RW