Manitou STACKY 10 FR D28, Operator'S Manual

Page: 14 / 60

1-10
STACKY operating and safety instructions 2012.12
- Move the stacker smoothly at an appropriate speed for the operating conditions
(ground profile, load on the stacker),
- Do not use the lifting or lowering controls when the lift truck is moving,
- Approach bends, narrow passages or swing doors, as well as any sector where
visibility is reduced, at reduced speed,
- Make sure you are in control of your speed under all circumstances,
- Brake gently, never abruptly,
- Do not leave the stacker unattended with the load raised (fig . F3),
- Look where you are going and always make sure you have good visibility along
the route,
- Leave a margin of safety when manoeuvring around obstacles,
- The operator must always remain uphill of the stacker on a ramp,
- Ramps must not be taken perpendicular to the axis of the slope,
- Never turn the stacker around on a ramp .
The operator must not move the stacker with the fork or tool in the raised position,
whether laden or unladen (fig . F4) .
The operator must not pass the load over a person when moving the stacker (fig . F5) .
INSTRUCTIONS
- Always move the stacker with the forks or tool in the transport position, i .e . at 150
mm from the ground,
- Place the tiller arm within the driving zone (2) (fig . F6) in order to unlock the electrical
safety system,
- The orientation of the tiller arm determines the direction of the stacker,
- When moving the stacker, the operator must walk in front of the machine,
- Gradually push one of the butterfly control switches up or down (1) (fig . F7)
depending on the chosen direction of travel .
As the stacker is fitted with an electronic speed controller, its speed is progressive and
increases according to the angular position of the butterfly control switch .
- To brake the stacker, release the butterfly control switch, which will return to the
neutral position, gradually bringing the stacker to halt,
- To stop the stacker, fully lower or raise the tiller arm (1) (fig . F6) or (3) (fig . F6), which
will actuate the electrically-operated brake .
The tiller arm automatically returns to the vertical position as soon as it is released .
The parking brake is then operated, stopping the stacker immediately .
The end of the tiller arm is fitted with an anti-crushing safety device (2) (fig . F7) that
protects the operator by reversing the direction of travel as soon as it is pressed . The
stacker will only stop when the pressure on the safety device stops or after 5 seconds .
This only applies when the stacker is in forward mode .
The button with a tortoise symbol (3) (fig . F7) moves the stacker at slow speed . This
function is very useful when manœuvring in confined spaces . When the button is
activated, the stacker travels at 30 % of its nominal speed . This function can be used
regardless of the control lever position (brake or drive) .
- Hold down the slow speed (tortoise) button (3) (fig . F7),
- Push the butterfly control switch up or down (1) (fig . F7) according to the chosen
direction of travel .
F4
F5
1 2
1
3
F7
F3
3
2
1
F6