Quick Installation
(1) Unplug the set-top box and television.
(2) Connect the antenna to the RF input of the box with coaxial cable.
(3) Connect the audio out port and video out port on the box to the audio in port and
video in port on the television respectively using audio/video cables.
(4) Plug and power on the set-top box and television.
Program Scanning
Satellite Setting
In Installation page, select Satellite Setting and press <OK>.
In the page displayed, you can use the <Left/Right> buttons to change the mode,
and set the proper satellite parameters.
(1) Press <Up/Down> to select among satellites.
(2) Press <OK> to confirm the selection of the currently focused satellite.
(3) Press <Right> to go to the satellite parameter setting page.
(4) Press <Red> to go into the SAT/TP Manager page.
(5) Press <Green> to go into the Automatic SAT Scan page.
(6) Press <Yellow>Goto position when motor is Diseqc1.2/USALS.
Note: Only the satellite checked in the setup manual can be scanned. You cannot
scan an unchecked sat.
Notice: Motor setting: Switch focus to motor items, switch to Disqc1.2/USALS ,
press <OK> enter Motor setting Page, after set Disqc1.2/USALS ,you must Press
Store save it .Unicable setting : As Motor setting.
6
