1
3
2
4
5
Distance between mounting
holes：135-165mm
The distance between the
mounting hole and the front of
the ceramic430-470mm
The distance from the inner circle
of the toilet to the front of the
ceramic＞375mm
Distance from water tank to the
front of ceramic＞505mm
Ceramic width≤380mm
9
Product installation
Adapt to ceramic dimension requirements
Preparation before installation
Before installing the toilet seat
1. Remove the existing toilet and close the
water supply system of the toilet.
2.Press the flush button to release the
pressure from the water supply pipe.
3.Place a container with water under the
water inlet valve.
4.Disconnect the toilet inlet valve from the
water supply pipe.
Note: When determining the location of the
circuit exit, follow local standards
1.The inlet of the separate seat is on the left
side and the bottom.
2.When the water inlet is from the bottom,
the ceramic holes must be able to pass
through the power cord and water inlet pipe;
Installation circuit outlet
1. Before installing the circuit, please reserve a power socket
within about 1 meter to the right of the toilet.
2. It is recommended to use waterproof sockets. Do not use extension
cords to connect the product.
