Page 31
Version 2023-06-07
Smoke extraction damper - SEDM-D
TPM 155/22
■
If the damper is equipped with end switches and these
switches are not used during operation (e.g. because of a
project change), they can be left on the damper and not
connected (they need not be dismounted).
■
These facts must be recorded in the respective operation
documentation of the damper (record books of the
damper, fire logs, etc.) and subsequently, adequate
function checks must be carried out.
End switches
■
The damper casing shall not be deformed in the course of
installation.
■
Once the damper is built in, the damper blade shall not
grind on the damper casing during opening or closing.
Installation / fixing the damper
■
Assembly, maintenance and damper function check can
be done only by qualified and trained person, i.e.
“AUTHORIZED PERSON” according to the manufacturer
documentation. All works done on the fire dampers must
be done according international and local norms and laws.
■
All effective safety standards and directives must be obse-
rved during damper assembly.
■
To ensure reliable damper function it is necessary to avoid
blocking the actuating mechanism and contact surfaces
with collected dust, fibre and sticky materials and solvents.
IX. ASSEMBLY, ATTENDANCE AND MAINTENANCE
Entry into service and revisions
■
Before entering the dampers into operation after
assembly and after sequential revisions, checks and
functionality tests of all designs including operation of the
electrical components must be successfully provided and
finished. Check the opening function of the damper blade.
After entering into operation, these revisions must be
done according to requirement set by national regulations.
■
In case that dampers are found unable to serve for their
function for any cause, it must be clearly marked. The
operator is obliged to ensure that the damper is put into
condition in which it is ready for function and meanwhile
he is obliged to provide the fire protection by another
appropriate way.
■
Results of regular checks, imperfections found and all-
important facts connected with the damper function must
be recorded in the "FIRE BOOK" and immediately repor-
ted to the operator.
■
It is recommended to provide periodical checks,
maintenance and service actions on fire equipment by
authorized persons. The authorized persons can be
trained by producer, or by authorized distributor. All
effective safety standards and directives must be
observed during fire damper assembly.
■
Visual inspection of proper damper installation, inner area
of a damper, damper blade, contact surfaces and silicon
seal.
X. ORDERING INFORMATION
Data label
■
Data label is placed on the damper casing (example)
WEIGHT (kg):
Dobříšská 550, 267 24 Hostomice, Czech Republic
MANDÍK, a.s.
DESIGN:
SERIAL.NO.:
DIMENSION:
TPM XXX/XX
R
CLASSIFICATION:
MANUAL
Cert. No.: 1391-CPR-XXXX/XXXX, DoP: PM/XXXX/XX/XX/X
EN 12101-8
