www.mc-techgroup.com
HEX5.0-1.08, HEX5.0-2.08 | 1.01.00
5
3 SAFETY INSTRUCTIONS
Follow these safety directions and instructions regarding installation, commissioning and
operation of the device:
Read this manual before commissioning and operating the product. Make sure to follow all safety
instructions.
Pay attention to the Certificate of Conformity (see appendix).
Installation and commissioning of electrical devices must be carried out only by qualified skilled
personnel in compliance with the current regulations.
The installation and commissioning of the device must conform to the requirements of VDE 0100
(IEC 364) ‘Regulations on the Installation of Power Circuits with Nominal Voltages below 1000V’
and must be in compliance with all relevant regulations and standards.
For use in hazardous area, observe the relevant national and international instructions and
regulations.
Before connecting the device, make sure to compare the supply voltage with the specified
voltage on the product label.
Protection against touching dangerously high electrical voltages: Disconnect the power supply
before opening the device for access. The device must be switched off and voltage free. Make
sure that all extern power supplies are disconnected.
Operate the device only in the permitted temperature range. For details please refer to the
technical data sheet or manual.
Make sure that you install the device in a weather-protected location. The device should not be
exposed to either direct sun, rain or moisture.
Installation, maintenance, inspections and any repairs of the devices must be carried out only by
qualified skilled personnel in compliance with the current regulations.
