14
HEX5.0-1.08, HEX5.0-2.08 | 1.01.00
www.mc-techgroup.com
10 ELECTRICAL CONNECTION
CARE!
When connecting the equipment, make sure that the supply voltage
is identical with the information provided on the model type plate!
WARNING!
Only carry out work on the open device, when the area has been
proved to be „safe“.
NOTE!
The installation and commissioning of the device must conform to
the requirements of VDE 0100 (IEC 364) ‘Regulations on the
Installation of Power Circuits with Nominal Voltages below 1000
V’
and must be in compliance with all relevant regulations and
standards.
The cables used for connecting the heater must have a diameter of 6-12 mm
(approx. 0.24” to
0.42”).
Depending on the ambient temperature at the mounting location, the cables used for the wiring
must be temperature resistant according to the requirements.
Connect the housing of the temperature controller, and if applicable the electrical connection
box of the HEX5.0-2.08, to earth (equipotential bonding).
Figure 3
Electrical connection HEX 5.0-1.08
Electrical connections electric heater HEX 5.0-1.08
