www.mc-techgroup.com
HEX5.0-1.08, HEX5.0-2.08 | 1.01.00
17
WARNING!
When working during operation:
High surface temperatures!
Touching may result in burns.
Wear protective gloves and assure that no unauthorized personnel
will touch the equipment!
WARNING!
Only carry out work on the open device, when the area has been
proved to be „safe“.
The installation and commissioning of the device must conform to the
requirements of VDE 0100 (IEC 364) ‘Regulations on the Installation
of Power Circuits with Nominal Voltages below 1000 V’ and must be
in compliance with all relevant regulations and standards.
Only change the fine-wire fuse F1 (1 AT 5x20) when the power supply
is disconnected.
DANGER!
Attention! The controller will be programmed according to the
required temperature class, and will leave M&C protected against
unauthorized access.
A wire strap on the terminal strip X1/5 protects against unauthorized
access.
The programming of the temperature class affects the complete
heater and can only be modified by M&C.
14 CLEANING
NOTE!
Clean the outside of the terminal box and the controller housing with
a damp cloth with a soap solution.
15 APPENDIX
Circuit diagrams
Connection and circuit diagrams option 2 x PT100
For additional manuals and data sheets, please have a look at our home page
