M&C GenTwo PMA1000V2.4, Instruction Manual

Page: 45 / 110

44
GenTwo® PMA1000 V2.4 | 1.00.00 www.mc-techgroup.com
NOTICE
Analyzer is not ready to set alarm after tapping “Online” or during
parameter setting!
Alarm and warning messages will not be updated!
Dangerous situation!
Close the parameter screen immediately after changing settings.
Note
When a settings screen is open, the display stays on this settings
screen. All other screens jump back to the start menu M2/S1, if the
touchscreen has not been used for 30 Minutes.
„
1 = Channel K1-Kn settings
The first screen of the menu item M4/S2 shows the selection wheel with the channel
settings “1 = channel K1-Kn” in the gray frame.
Fig. 45: Channel settings
Tap on the word “Online”. The list of basic settings opens.
Note
The display shows only part of the list. Scroll down the list by swiping
vertically or by pressing the arrow buttons to have a look at all
parameters.
The following figure shows the upper part of the basic settings list. The existing channel
names are on top of the list. To change a channel name, tap on the “Alias name” field. The
field is highlighted in orange and the current name of the channel “Alias” appears in the
edit field. Tap on the edit field to open the keypad.