1025196
BC
Required For This Page:
15/16” Wrenches
a. Apply a small amount of Dark Lithium Grease to the
remaining 1/2” x 2 1/4” Hex Bolts (BC).
b. Have at least four adults lift the top of the Pole so there is
no weight on the Backboard.
c. Two other adults should then lift the top of the Backboard
off the ground and align the holes at the top of the
Backboard channels with the holes in the Upper Extension
Arms (AS).
d. For each arm, slide a greased bolt (BC) through the Upper
Extension Arm, a 1/2” Washer the Backboard. Secure with
a 1/2” Nylock Jam Nut (EB).
Tighten the Nut securely,
but make sure the Bolts can still rotate.
STEP 17
EB
YA
(2)
(4)
(2)
BC
YA
EB
AS
3/4” Wrenches
AS
AS
a. Position the Trigger (AU) inside the Handle,
making sure the Trigger bar lines up with the
holes in the Handle (AP) and the end of the
Trigger rests between the Trigger Pin (MB)
and the Bolt through the Rear Lifter Arms
and Handle.
Note: The end of the Trigger must rest
on top of the Bolt and under the Trigger
Pin (MB).
b. Insert the 3/8” x 8 1/2” Bolt (QB) through
the Handle and Trigger and secure it with a
3/8” Nylock Jam Nut (QA).
Tighten the
Nut until it is flush with the edge of the
Bolt.
c. Apply White Grease to the Trigger Pin (MB)
in the areas shown.
STEP 18
QA
HH18700
QB
(1)
(1)
9.88”
(Not actual length)
9/16” Wrenches
QB
QA
AP
AU
Apply
grease here
YA
