0
AP
HD
HB
NN
ZC
ZC
STEP 2
STEP 3
a. Place the Gas Springs on the back of the Pole
with the Outside Springs (AD) on the outside
and the Center Gas Spring (MM) in the middle
position). Make sure the holes in the Spring
Covers (AI) line up with the holes in the
Brackets and the Springs. The notch in the
Covers should fit around the brackets on the
pole.
b. Slide a 5/16” x 8” Hex Bolt (MC) through each
of the Covers, Brackets and Springs.
c. Secure each Bolt with a 5/16” Nylock Nut
(MA).
Tighten the Nut only until it is flush
with the end of the Bolt.
a. Position the Handle (AP) next to the lower pair of holes in
the Pole. The Handle must be on the side of the Pole with
the Springs.
b. Apply a small amount of Dark Lithium Grease to a 1/2” x
8 9/16” Hex Bolt (HD).
c. Slide the greased Bolt (HD) through the 1/2” O-Ring (AC),
the Handle, a 1/2” x 1/2” Spacer (HF), the Pole, the other
1/2” x 1/2” Spacer (HF), the other side of the Handle and
final O-Ring (ZC).
d. Secure the Bolt with a 1/2” Nylock Nut (HB).
Tighten the
Nut only until it is flush with the end of the Bolt.
MC
MA
MC
HB
NN
Required For This Page:
3/4” Wrenches
HD
1/2” Wrenches
(Not actual length)
(1)
(1)
(1)
(2)
(1)
9.94”
1028352
EH0028
MA
a. Slide the small notched end of one of the Gas Spring Covers (AI) over the top of each Gas Spring (AD (x2), & MM) as
shown.
STEP 1
AD & MM
AI
ZC
AD
AD
MM
(2)
(Not actual length)
The Center Gas Spring (MM)
has two oblong holes along
with two round holes in the
bottom bracket.