Malvern MPT-2, User Manual, Page: 25 / 85

Connection and accessory preparation Chapter 2
MPT-2 & Degasser Page 2-3
Note
Initially the accessory will have been commissioned by a Malvern Instru-
ments representative. The below information describes how to fit any new
tubing.
ill 8751
Connecting the tubing (titrator to degasser)

Position the titrator and degasser suitably for operation, and ensure the tubing
lengths will comfortably reach the degasser from the titrator.

Push a line of tubing through the titrant container clamp above the titrant con-
tainers until it reaches the base of the container. Run the line of
tubing
from
the titrant containers in the titrator to the degasser input.

Push the tubing through the
connector
and slide a
ferrule
over the tubing
end

; note the direction of the ferrule
taper

.
To Degasser
From Degasser
2
1
MAN0318-4.0 - MPT-2 Autotitrator-Degasser.book Page 3 Tuesday, September 4, 2012 12:15 PM