18
|
Then press the button on the hand controller upwards (S1)
until an audible locking sound can be heard. The electric
back rest function is once again active.
Engaging the release mechanism (low voltage system):
Press the corresponding button (S2) on the hand controller.
The back rest drive is ready for use in any position after mov-
ing a short distance.
Caution! When activating the lever, take care
to ensure no objects or parts of the body are
located under the back rest. When released,
the back rest must also always be supported
by hand to prevent sudden lowering.
Upper leg section
Use the corresponding buttons on the hand controller to ad-
just the upper leg section.
(Upper leg section operating buttons)
For safety reasons, this position should only be adjusted by
medical personnel.
The lower leg section can be put into a horizontal position by
nursing staff using an adjustable notched support. (Extended
leg elevation)
D E S C R I P T I O N O F F U N C T I O N
Depending on the design and type of care bed, the bed can
be put into the following positions by adjusting the back rest,
the upper leg and the lower leg sections as well as the height
of the bed:
Back rest
Use the corresponding buttons on the hand controller to ad-
just the back rest.
(Back rest buttons)
In its range of movement, the back rest has a length adjust-
ment to the head section of the bed of 120 mm.
This function (mattress compensation) allows the occupant to
sit in a comfortable position without compressing or restrict-
ing the stomach or upper body.
Release mechanism of the
Back rest/CPR
(optional)
When using the back rest release mechanism, hold the back
rest firmly in the position engaged and take some weight off
it if possible. Pulling firmly on the release mechanism allows
the back rest to be disengaged and lowered manually into
the final position.
Engaging the release mechanism (ICS control):
Press the corresponding button (S2) on the hand controller
downwards until the sound of the motor is no longer audible.
