Malsch AYLEEN CARE BED, Instruction Manual

Page: 31 / 44

| 31
Fig. 2 (dimensions of a split side rail)
Check whether the required spacings are also complied with un-
der load. Check dimensions A and D with a tool in line with
IEC 60601-2-52:2009 A MD:2015. The test force for dimension
A is 250 N.
Dimensions Requirement
[mm]
A
The largest dimension in at least one direc-
tion between components of the side rail/
handrail in all commonly used positions. A ≤ 120
B
Thickness of the normal mattress without
compression as stated by the manufac-
turer.
as stated
by the
manufacturer
C
Distance from the upper edge of the side
rail to the upper edge of the mattress
without compression with the sleeping
surface in a level position.
C ≥ 220
D
Distance between head/foot board or ac-
cessories to the side rail/handrail is parallel
to the sleeping surface in a level position.
This also applies to extended foot sections.
D ≤ 60 or
D ≥ 318
E
Distance between split side rails with
reclining surface in a level position. E≤ 60 or
E ≥ 318
F
The largest dimension in at least one direc-
tion of every opening below the side rail. if D ≥ 250 ;
F≤ 60
if D ≤ 60;
F≤ 120
G Length of the side rail(s) G ≥ 2/3 H
H
Inner distance between headboard and
footboard without any extension of these
parts.
No
requirements
3. Functionality check of brakes
Depending on the variant, the functionality of the brakes must
be checked in every position. With electrical brake systems,
check whether the brakes fully retract and extend.
4. Functionality check of lifting motors
Move all lifting motors to their end position and back again.
When doing so, please observe the following points:
§
Any unusual noises generated
§ Synchronism of the lifting motors
§
Smooth operation of the lifting motors
§
Correct path of the lifting motors
§ Automatic switch-off in the end position
The travel path of the lifting motors may vary depending on the
model variant. If in doubt, please contact our customer service.