Chapter 2: Installation
14
Malibu Networks AirMAX“ CPE/BTS
8.
Then for each of the clamps, place two bolts
through the clamp on one side of the mast and then
place another clamp over the bolts on the opposite
side of the mast. Secure the bolts with the washers
and nuts supplied (one each for each bolt).
9.
Tighten the nuts securely enough to bite into the
mast and prevent slipping, but not overtightened to
the point of damaging the mast (particularly on
aluminum masts).
10.
Repeat this procedure for the other clamps.
CPE Directional
Antenna Mounting
1.
Install a customer-supplied mast of 1 to 2 inches in
diameter. Position the mast for true vertical using a
level. Brace the mast as necessary so that it
remains stationary in expected wind conditions.
2.
Place Antenna Bracket (articulated) on back of
directional antenna and secure with the two nuts
suppied (see figure).
3.
Place U-bolt through the bracket end-plate, around
the mast, and through the Antenna bracket. Secure
the antenna with two nuts over the threaded ends
of the U-bolt. Leave nuts slightly loose so you can
adjust the antenna.
Summary of Contents for AirMAX 240
