MAKSIWA CBC.T, Instruction Manual

Page: 18 / 80

18
5 Operation
5.4 Glue pot unit
The glue pot unit spreads the hot melting glue on the work-piece
to be edged. Thermo adjustment on the PLC checks the heating
and functioning of the glue pot. For correct use please follow
instructions:
1. Fill the glue pot to approximately 1cm below edge of the pot.
• Make sure that the type of glue used is compatible with the
conditions and the technical characteristics of the machine.
Suggested Glues:
• Kleibert 773.3 200°C
• Jowat JOWAT 280.30 200°C
2. Adjust the electronic thermostat at the temperature
corresponding to the one suggested by the manufacturer. (it
has been set at 190°C in the factory).
3. The glue spreader starts turning automatically when the temperature reaches 180°C.
4. The quantity of glue spread can be adjusting by turning the knob B. (Turn clockwise to decrease
the amount; turn counterclockwise to increase)
5. The knob D is used to move the glue pot forward or backward. It is tightened at factory to avoid
damage during transportation. To use the machine, completely slacken the knob till you reach
the locking nut E which is adjusted at the factory and its position
MUST NOT
be modified for
any reason.
Lubrication of glue spreader
Users should do lubrication with
grease gun every 30-working
hour by aligning the nozzle into
the hole C. The lack of periodic
lubrication can create serious
damage and you will have to
replace the glue pot. To reset the
functioning of machine, push the
“OFF” button on the control panel
for 10 seconds.
Only lubricate with high temperature grease.