MAKSIWA CBC.T, Instruction Manual

Page: 20 / 80

20
5 Operation
5.6 Front/Rear Trimming
This unit is extremely precise, automatically end-trims both froth/rear exceeding edge. Made of
solid steel, it guarantees a clean, accurate cut on the leading and tailing edges of the panel being
processed. This is done completely automatic and the cut is referenced directly from the panel via
micro-switches with no need to adjustments when running different length panels.
Adjust Tracing Pads
1. Open the feeder to stop all electrical and
pneumatic functions. Place the main switch on
OFF and detach the hose of compressed air.
2. To check whether the tracking pads are in line
with the panel, lay a panel against the front
tracing pad, raising and lowering the unit.
3. If not, act on screws A and B which compress
the spring washers.
4. Repeat the above steps on the rear tracing pad.
5. Once obtained the perpendicular of the tracing
pads on the table, by screwing or unscrewing
in the same way and with the same number
of turns the two screws A and B you obtain a
minor or major length of the cut edge.
Change Blades
1. Take off the suction hood.
2. Loose the screws of the blade.
3.
Take off the washer and the front blade.
4. Take out the spacer
5. Tilt the rear blade and take out from
the spindle.
6. Assemble new blade with same
direction.