![background image](http://html.mh-extra.com/html/makita/xfd15/xfd15_instruction-manual_1722666008.webp)
8 ENGLISH
Adjusting the fastening torque
1
2
3
Ź
1.
$GMXVWLQJULQJ
2.
Graduation
3.
Arrow
7KHIDVWHQLQJWRUTXHFDQEHDGMXVWHGLQOHYHOVE\WXUQLQJWKHDGMXVWLQJULQJ$OLJQWKHJUDGXDWLRQVZLWKWKHDUURZ
RQWKHWRROERG\<RXFDQJHWWKHPLQLPXPIDVWHQLQJWRUTXHDWDQGPD[LPXPWRUTXHDW
marking.
The clutch will slip at various torque levels when set at the number 1 to 20. The clutch does not work at the
marking.
%HIRUHDFWXDORSHUDWLRQGULYHDWULDOVFUHZLQWR\RXUPDWHULDORUDSLHFHRIGXSOLFDWHPDWHULDOWRGHWHUPLQHZKLFK
torque level is required for a particular application.
The following shows the rough guide of the relationship between the screw size and graduation.
Graduation
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Machine screw
M4
M5
M6
Wood
screw
Soft wood
(e.g. pine)
–
ø3.5 x 22
ø4.1 x 38
–
Hard wood
(e.g. lauan)
–
ø3.5 x 22
ø4.1 x 38
–
ASSEMBLY
CAUTION:
Always be sure that the tool is
VZLWFKHGRႇDQGWKHEDWWHU\FDUWULGJHLVUHPRYHG
before carrying out any work on the tool.
Installing or removing driver bit/drill bit
Optional accessory
1
2
3
Ź
1.
Sleeve
2.
Close
3.
Open
7XUQWKHVOHHYHFRXQWHUFORFNZLVHWRRSHQWKHFKXFNMDZV
Place the driver bit/drill bit in the chuck as far as it will go.
Turn the sleeve clockwise to tighten the chuck. To remove
the driver bit/drill bit, turn the sleeve counterclockwise.
Installing hook
CAUTION:
When installing the hook, always
VHFXUHLWZLWKWKHVFUHZ¿UPO\
,IQRWWKHKRRNPD\
FRPHRႇIURPWKHWRRODQGUHVXOWLQWKHSHUVRQDOLQMXU\
CAUTION:
Use the hanging/mounting parts for
their intended purposes only.
Using for unintended
SXUSRVHPD\FDXVHDFFLGHQWRUSHUVRQDOLQMXU\
2
3
1
Ź
1.
Groove
2.
Hook
3.
Screw
7KHKRRNLVFRQYHQLHQWIRUWHPSRUDULO\KDQJLQJWKHWRRO
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.