R
epair
[4] DISASSEMBLY/ASSEMBLY
[4]-11. Starter unit (cont.)
P
18
/2
6
ASSEMBLING RECOIL STARTER
(5) While turning Reel counterclockwise, mount it in Starter case complete. Then hook the inner end of S
piral spring
in
the slit of the shaft portion of Starter case complete. (
Fig. 53
)
Note:
You need not use force to mount Reel in place.
(6) Set Collar and two Swing arms in place on Reel. Be sure to insert each Swing arm through the slot of Reel.
Then fasten them to Reel with 5x12 Tapping screw. (
Fig. 54
)
Note:
Reel is not properly set in place if the rotation of Reel is slow after the screw is fastened.
In this case, repeat steps 5) and 6) until normal rotation of Reel is obtained.
(7) Hook Starter rope on the U-shaped notch of Reel. Then, while pulling Starter rope, turn Reel counterclockwise. (
Fig. 55
)
Release Starter rope from the U-shaped notch and Starter rope will be wound around Reel due to the rotational force of
Spiral spring. Repeat this operation until the slack is completely removed from Starter rope.
Fig. 53
Fig. 55
Fig. 54
Collar
inner end of Spiral spring
shaft portion of Starter case complete
slit
Swing arm
Swing arm
slot of Reel
U-shaped notch
Reel
Starter case complete
Starter rope
Starter knob
