R
epair
P 11 / 13
Round bars for blocking
compression spring 28 and
spring holder
3. Assemble link plate by fastening hex socket
head bolt M6 x 20 as illustrated in Fig. 13E.
And then, take off round bars which were
inserted for blocking compression spring 28
and spring holder, as illustrated in Fig. 13D.
Hex bolt M10 x 105
Hex socket head
bolt M6 x 20
Link plate
Fig. 13E
Fig. 13D
< 5 > Adjusting the saw blade's angle
1. 0° bevel and miter angle (right angle)
Push the motor section to the nearest position
to guide rule, and fasten screw M6 x 20 to secure
the motor section in the above position.
Loosen lever 125 to the direction indicated
with arrow as illustrated in Fig. 14A.
Screw M6 x 20
Lever 125
Saw blade
Hex bolt M8 x 50
View from lever 125 side
Fig. 14A
Fig. 14B
Turn hex bolt M8 x 50 two or three revolutions
counterclockwise so that the motor section tilts
the right.
Fig. 14C
Adjust the saw blade's right angle as illustrated in
Fig. 14C.
After adjusting, fasten hex bolt M8 x 50 again.
Guide rule
Guide rule
Turn base
Turn base
1R208
"90 degree set square"
Adjusting
bevel angle
Adjusting
miter angle