R
epair
P 15 / 16
<15> Assembling torque limiter section
1. Assemble ball bearing 6001LLU, flat washer 12
(24mm in outer diameter) and torque limiter
to spiral bevel gear 10. (see Fig. 26)
< Note >
Be careful not to lose pin 4 for lock of
circular nut.
2. Assemble 2 pcs. of change keys into the groove
of the shaft of spiral bevel gear 10.
Set flat washer 12 (24mm in outer diameter)
and retaining ring S12 on the above assembled
change keys.
And then assemble flat washer 12 (28mm in
outer diameter) adjusting it in the concaves
of change keys. (see Fig.26)
3. Assemble retaining ring S12 into the groove
of the shaft of spiral bevel gear 10 by sliding
down 2 change keys. And make sure, whether
the retaining ring S12 is assembled in the groove
firmly. (see Fig.26 and 26A)
< Note >
Be careful not to expand the retaining ring 12
too wide.
4. Assemble slide plate, compression spring 3
and guide pin 2 to change link. (see Fig.26)
5. Assemble flat washer 12 (28mm in outer
diameter) into the groove of change link
and install the assembled torque limiter
section to the ball bearing 608LLU which is
installed in the gear housing. (see Fig.27)
Concave of
change key
Change key
Flat washer 12
(28mm in diameter)
Retaining ring S12
Flat washer 12
(24mm in diameter)
Concave for
retaining ring
Ball bearing 6001LLU
Straight bevel gear 10
Fig. 26
Pin 4
Circular nut M25-35
Fig. 26A
Fig.27
Torque limiter
Slide plate
Compression
spring 3
Guide pin 2
Change link
Flat washer 12
(28mm in diameter)
Groove of
change link