R
epair
P 7 / 16
3) Insert a stainless scale into the change lever assembling hole of crank housing, and put the another end
of the same scale on side handle base as illustrated in Fig. 5.
4) Strike side grip with plastic hammer. So crank housing cover can be separated together with side grip
from crank housing as illustrated in Fig. 5A.
Stainless scale
Insert into the
change lever
installing hole
of crank housing.
Side handle base
Fig. 5A
Fig. 5
Fig. 6
Crank housing cover
5) Disassemble handle by unscrewing pan head screws and tapping screws as illustrated in Fig. 6.
6) Disassemble connector and fix rod as illustrated in Fig. 6.
7) And then, remove pick-up coil as illustrated in Fig. 6.
Tapping screws M5x20
Pan head screws M5x20
Handle
Connector
Fix rod
Pick-up coil
Controller
Control dial
< Note > Keep the following matters in order to avoid the disconnection, when removing pick-up coil and connector.
1. After disassembling fix rod, remove pick-up coil.
2. When separating connector from controller, hold controller with a hand,
and pull connector itself, holding it with another hand. Do not remove pulling connector's lead wires.
8) Pull off 3 terminals (white, red and black) from controller as illustrated in Fig. 7.
Then, controller can be removed from motor housing.
3 terminals pulled off
from controller
White
Red
Black
Controller
Fig. 7