4
ENGLISH
Explanation of general view
1
Lock button
2
Speed control screw
3
Switch trigger
4
Higher
5
Lower
6
Lamp
7
Reversing switch lever
8
Arrow
9
Speed change knob
10
Action mode changing lever
11
Grip base
12
Side grip (auxiliary handle)
13
Teeth
14
Protrusions
15
Chuck key
16
Sleeve
17
Ring
18
Depth gauge
19
Blow-out bulb
20
Vent holes
SPECIFICATIONS
• Due to our continuing programme of research and
development, the specifications herein are subject to
change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.
SPECIFIC SAFETY RULES
GEB003-4
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to hammer drill safety rules. If you use this power
tool unsafely or incorrectly, you can suffer serious
personal injury.
1.
Wear ear protectors with impact drills. Exposure
to noise can cause hearing loss.
2.
Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3.
Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a “live” wire may
make exposed metal parts of the power tool “live”
and could give the operator an electric shock.
4.
Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
5.
Hold the tool firmly with both hands.
6.
Keep hands away from rotating parts.
7.
Do not leave the tool running. Operate the tool
only when hand-held.
8.
Do not touch the bit or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
9.
Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Model
HP2050/HP2050F
HP2051/HP2051F
Speed
High
Low
High
Low
Capacities
Concrete
20 mm
-----
20 mm
-----
Steel
8 mm
13 mm
8 mm
13 mm
Wood
25 mm
40 mm
25 mm
40 mm
No load speed (min
–1
)
0 - 2,900
0 - 1,200
0 - 2,900
0 - 1,200
Blows per minute
0 - 58,000
0 - 24,000
0 - 58,000
0 - 24,000
Overall length
362 mm
360 mm
Net weight
2.5 kg
2.5 kg
Safety class
a
/II
