R
epair
P 4 / 12
< 3 > Assembling motor section
Hex socket head
bolts M6x50
Fig. 8
Fig. 7
Hex socket head
bolts M6x40
Hex socket head
bolts M6x50
Fig. 9
Lead wires
Handle set
Pan head
screws M5x16
Holder cap plate
Rubber ring 6
Brush holder cap
Carbon brush
Rear cover
Hex socket head
bolts M5x18
Fig. 10
(1) Make sure that seal has been previously mounted to armature. Mount armature and then baffle plate to
crank housing. See Fig. 7.
(2) Make sure that flat washer 18 has been previously mounted in the bearing assembling hole of motor housing
(rear cover side). Mount motor housing to crank housing by pressing. Fasten it with hex socket head bolts
M6x50. See Fig. 8.
(3) Mount handle set. Fasten it with hex socket head bolts M6x50 and hex socket head bolts M6x40. See Fig. 9.
Be careful, not to pinch lead wires with handle set in this step.
Crank
housing
Motor
housing
Armature
Baffle plate
(4) Mount rear cover and fasten it with hex socket head bolts M5x18. Mount carbon brushes and fasten it with
brush holder cap, rubber ring 6 and holder cap plate. See Fig. 10.
Flat washer 18
Seal
