R
epair
P 6 / 12
Fig. 15
Fig. 16
Fig. 17
(1) Take off hex socket head bolts M8x30 and remove tool holder from barrel. And take off inner parts from barrel.
See Fig.15.
(2) Put 1R032 "Bearing setting plate" into barrel. And remove cylinder liner from barrel by pressing the 1R032 put into
barrel with arbor press. See Fig.16.
Hex socket
head bolts M8x30
Adhesive is applied
to hex socket head
bolts M8x30
Tool holder
Barrel
< 5 > Removing cylinder liner from barrel
(1) Put No.1R201"Jig for Retainer Ring" on retainer ring, and pass No.1R282"Round Bar for Atbor" through the screw
hole for hex socket head bolt M8x30. Press the round bar for arbor with arbor press, so retainer ring is pressed sown.
And pin 4 can be removed. See Fig. 17. Retainer rings and compression springs 4 can be removed.
< 6 > Disassembling tool retainer section
1R218
Adjuster sleeves
Cylinder liner
Urethane ring 48 (2 pcs.)
Urethane ring 48 (2 pcs.)
Rubber ring 52
Seal holder
Tool guide
Flat washer 48
1R032
Bearing setting plate
Pin 4
Rounfr bar
for arbor
Retainer ring
Retainer rings
1R201
Jig for Retainer
Ring
Compression
spring 4
Compression
spring 4
