R
epair
P 3 / 12
< 2 > Disassembling motor section
(1) Remove holder cap plate by unscrewing pan had screw M5x16. Remove rubber ring 6, brush holder cap
and carbon brushes. See Fig. 2.
(2) Remove handle set from crank housing by unscrewing hex socket head bolts M6x50 and M6x40.
However, the handle set can not be separated completely from motor housing in this step,
because it is still connected with lead wires. See Fig. 3.
(3) Unscrew hex socket head bolt M6x50. See Fig. 4.
(4) Strike crank housing as illustrated in Fig. 5. Then, motor housing can be separated from crank housing See Fig. 5.
(5) Strike crank housing as illustrated in Fig. 6. Then, Armature and baffle plate can be separated from crank housing
See Fig. 6.
Pan head
screws M5x16
Holder cap plate
Rubber ring 6
Brush holder cap
Carbon brush
Rear cover
Hex socket head
bolts M5x18
Hex socket head
bolts M6x50
Hex socket head
bolts M6x40
Hex socket head
bolts M6x50
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Lead wires
Plastic hammer
Crank
housing
Baffle plate