P 3/ 15
(1) Remove Sprocket guard, Guide bar and Saw chain from machine.
(2) Insert Small-slotted screwdriver into the gap between Crank shaft and Retaining ring E type 6, and then twist Retaining
ring E type 6 using the slotted blade. (
Fig. 4
)
(3) Remove Flat washer 8 and Retaining ring E type 6 from Crank shaft.
(4) Release chain brake by turn Hand guard toward Tubular handle to remove Clutch drum assemble.if chain brake works.
(5) Remove Clutch drum assembly. (
Fig. 5
)
(1) Check that the following portions of Clutch drum assembly do not have damage/ wear. (
Fig. 5
)
• Inside
• Chain-sprocket portion
• Needle bearing portion
If there is damage/ wear on Clutch dram assembly, replace it to new one.
(2) Apply a little amount of Makita grease N No. 2 to the needle bearing portion of Clutch drum assembly.
(3) Set Clutch drum assembly, Flat washer 8 and Retaining ring E type 6 in place.
Note
: Be sure to use the new Retaining ring E type 6.
R
epair
ASSEMBLING
DISASSEMBLING
[2] DISASSEMBLY/ ASSEMBLY
[2]-2. Clutch drum section
Small-slotted screwdriver
• Chain-sprocket portion
• Needle bearing portion
• Inside of Clutch
drum assembly
Retaining ring E type 6
Retaining ring E
type 6
Flat washer 8
Flat washer 8
Crank shaft
Fig. 4
Fig. 5