![background image](http://html1.mh-extra.com/html/makita/dhr165/dhr165_technical-information_4065069006.webp)
[3] DISASSEMBLY/ASSEMBLY
[3]-2. Armature (cont.)
Fig. 6
DISASSEMBLING
Lock button must be pushed into Change lever
deeper than the usual operation.
(2) In case Armature cannot be removed by the steps mentioned in the previous page, disassemble the machine as drawn
in the following and the next page.
(3) Remove Change lever complete, and separate Inner housing section from Gear housing.
Then separate Tool holder section and Joint plate from the Inner housing section as drawn in
Fig. 6
.
5. Remove Tool holder section.
6. Detach Joint plate from the groove of Clutch cam and remove
Joint plate from Piston cylinder.
3. Change lever complete is removed from
Gear housing complete.
Change lever
complete
Change lever
complete
Tool holder section
Joint plate
Groove of Clutch cam
Piston cylinder
Inner housing
Tool holder complete
Workbench
Gear housing complete
Tool holder complete
Armature
4. Remove Inner housing complete and Armature section from Gear
housing complete by attaching the top of Tool holder complete
on workbench and sliding down Gear housing complete.
2. Turn Change lever to the left further than hammer drill mode position
while pushing Lock button deeper than the surface level of Change lever.
1. Set Change lever complete to hammer
drill mode while pushing Lock button.
Lock button
P 6/ 17
R
epair