8 / 35
Fig. 18
7
Assemble Clutch assembly 8M (DFT087F)/Clutch
assembly 12M (DFT129F) [2] while lifting up Gear
assembly [1] slightly, then assemble them to
Housing [3].
Fig. 19
8
Assemble the following parts to Housing R [1]:
Change plate [2]
Note
Move Change plate [2] to Motor side.
Compression spring 2 [3]
Switch lever [4]
USB cover [5]
Note
Stay USB cover [5] close.
Plate [6]
Note
Assemble Plate [6] so that its surface with numerical
value faces Housing L [7].
Fig. 20
9
Assemble Housing L [1] with Pan head screws
M3x20 [2] (8 pcs).
Note
If Hex nuts M3 fall off from Housing R, tighten Pan
head screw M3x20 [2] approximately 2 times, then
press-fit Hex nuts M3 by tapping them with 1R479.
Pass Connector through Housing L [1] if Unit
(Herutu module) is used.
[1]
[2]
[3]
[2]
[5]
[1]
[3]
[4]
[6]
[7]
[2]
[1]