P 5 /13
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Gear Housing Cover Section (cont.)
5) Disassemble Gear housing cover section by following the steps 1 to 5 described below in Fig. 8 to Fig. 11.
Stop ring E-3
Fig. 8
Fig. 11
Fig. 9
Fig. 10
Pan head screw
M4x10 (4 pcs)
Linear guide
(2 pcs)
Slider
Pin 4 (268090-1)
Leaf spring
[with Pin 4 (256117-9)
and Plane bearing 4]
DISASSEMBLING
Gear housing cover complete
Pin 4
(268090-1)
Rod
Slider
1. Remove Stop ring E-3
from Pin 4 (268090-1)
with a small slotted
screwdriver.
Gear housing cover section
(viewed from Motor housing side)
3. Disconnect Slider from Rod
by pulling Pin 4 (268090-1)
in the direction of the arrow.
2. Pull down Rod until it stops.
4. Pull off Rod from
Gear housing cover
complete.
5. By unscrewing four M4x10 Pan head screws, Gear housing cover section
can be disassembled as illustrated below.
Gear housing
cover complete
Plane bearing 4
Leaf spring
1) Assemble Pin 4 (256117-9) and Plane bearing 4 to Leaf spring if they are removed.
2) Put Leaf spring in place into Gear hosing cover complete. (Fig. 12)
3) Assemble Blade holder section to Gear housing cover complete as illustrated in Fig. 13.
Pin 4 (256117-9)
Motor housing side
Rod
Blade holder
Fig. 12
Fig. 13
ASSEMBLING
Gear housing cover complete
Note: Plane bearing 4 must be placed
on Motor housing side.
hook
Note: The through hole of Rod and
the hook of Blade holder
must be placed as illustrated
to left.
through hole
Blade holder section
Motor housing side
