P 13/13
Fig. 43
W
iring diagram
Route Lead wires as illustrated in Fig. 43.
1 Lead wires of Endbell (black):
Route between the rib and the boss, and connect to No.M1 terminal of Switch.
Note: Be sure to fix with Lead wire holder A.
2 Lead wires of Endbell (red):
Route between the rib and the boss, and connect to No.M2 terminal of Switch.
Note: Be sure to fix with Lead wire holders A and B.
3 Lead wire of Switch (black):
Connect to minus pole of Terminal
Note: Be sure to fix with Lead wire holder A.
4 Lead wire of Switch (orange):
Connect this lead wire to plus pole of Terminal.
Note: Be sure to fix with Lead wire holder A.
5 Lead wire of Light circuit:
Route between the pin and the inside wall of Handle (L).
Wiring in Handle (L)
Lead wire holder B
Lead wire holder A
Switch lever
Endbell complete
Switch
Handle (L)
Terminal
FET
Gear housing complete
Lead wires of Endbell (red, black)
must be tight in this area.
Gear housing cover complete
Light circuit
boss
rib
pin
Connector
Handle (L)
Handle (R)
stepped edge
Heat sink
Assembling Heat sink to Handle (L)
1
2
3
4
5
Heat sink
Be sure to place the stepped edge on Handle (R) side.
