Route Stater lead wires between Controller
and emboss of Housing L
Connect Flag terminals with Terminal so that
Lead wires face outside of Terminal. Do not
route the Lead wires between Terminal and Rib B.
Terminal viewed from the upper side
Fit 3-pin connector into the room on
Housing L as illustrated below, and then
put 6-pin connector on 3-pin connector
as illustrated right.
Controller
Terminal of
Stator
Rib B of
Housing L
emboss of
Housing L
Fig. D-2A
W
iring diagram (for BBC300L and AT-3630)
P 1
1
/ 1
2
Flag terminal
Lead wires
3-pin connector
6-pin connector
5-pin
connector
Room on Housing L
for 3-pin connector
Do not put Lead wires on 3-pin connector and 6-pin connector.
Power supply cord unit
Tube
Strain
relief
Rib A
Align one end of Power supply cord with Rib A, and
secure Power supply cord unit with Strain relief.
Do not pinch Tube between Strain relief and Housing L.
Room on Housing L
for 5-pin connector
Terminal
Face the tube side of Power supply cord unit to Strain relief side, and fix Power supply cord unit with Strain relief.
(No tube on Powr supply cord unit )
(Tube side of Powr supply
cord unit with tube)
Flag receptacle
Reverse switch
Flag receptacle with sleeve
Grip L
Insert Connector into
the room of Grip L as
illustrated left.
Be careful to the
direction.
Slacks in Lead wires have to
stored in the rooms designated
in arrows and circles.
