MakerBot Replicator 2, User Manual

Page: 17 / 60

17
iNSTALLiNg FiLAmENT gUiDE TUBE AND SPOOL hOLDEr
B SETTING UP YOUR MAkERBOT REPLICATOR 2 DESkTOP 3D PRINTER
7a. Locate the filament guide tube. Insert one
end into the hole at the top of the extruder
and push the tube in as far as it will go.
7b. Insert the other end of the filament guide
tube into the left guide tube holder [when
viewed from the back] on the back of the
MakerBot Replicator 2. Make sure that the
end of the filament guide tube is flush with
the bottom of the guide tube holder. The
filament guide tube should not hang down
past the bottom of the guide tube holder.
8a. Locate the spool holder. Install
the spool holder on the left side of the
MakerBot Replicator 2 [when viewed from
the back]. Tilt and fit the spool holder into
the opening on the back of the MakerBot
Replicator 2.
7
Installing the Filament Guide Tube
8
Installing the Spool Holder