14
below the bPS will flash. Press and hold the inquiring key
for more than half a
second (less than 2 seconds) to determine whether the bPS function is used or not. If
used, the corresponding word is “ON”, if not, the word is “OFF”. It can be determined
by yourself.
③
Confirm the Bypass output selecting interface. After selecting ON or OFF, press and
hold the function setting key
for more than half a second (less than 2 seconds),
Now, the bPS setting function is completed and the “ON” or “OFF” below the “bPS” will
light without flash.
④
Set the BPS tolerance range. Short press the scroll key
or
for more than half
a second (shorter than 2 seconds)to select the voltage range in percentage.
+5%,+10%,+15%,+25%(default is +25%)
，
then short press function setting key
for more than half a second (shorter than 2 seconds)to confirm the selection,
then to set the minus range
⑤
To set the minus range in the same way.
④
Exit from the setting interface. Press and hold function setting key
for more than
2 seconds, exit from the setting interface and return to main interface.
⑤
After setting bPS as ON, when mains power plugged in without turning on the
UPS or no mains power plugged in, there is bypass output but no power down backup
function.
4.3.3
Output voltage setting(3)
①
Enter the setting interface. Press and hold the function setting key
for more
than 2 seconds, then come to setting interface, Press and hold the inquiring key
for
more than half a second(less than 2 seconds), select the function setting, choose
output voltage setting interface, at the moment, the letters “OPU” will flash
②
Enter the output voltage selecting interface. Press and hold the function setting
key
for more than half a second(less than 2 seconds), then come to setting
interface of output voltage OPU, at this time, the letters “OPU” will light for a long time.
