12
4.2.2
Turn off operation
Turn off the UPS in line mode
①
Press and hold the OFF key for more than half a second to turn off the UPS and
inverter.
②
After UPS shutting down, LED go out and there is no output. If output is needed,
you can set bps “ON” on LCD setting menu.
Turn off the UPS by DC without mains power
①
Press and hold the OFF key for more than half a second to turn off the UPS.
②
When turning off the UPS, it will do self-testing firstly. LED light and go out
circularly and orderly until there is no display on the panel.
4.2.3
UPS self-test/mute test operation.
①
When UPS is in line mode, press and hold the self-test/mute key for more than 1
second, LEDs light and go out circularly and orderly. UPS comes to self-test mode and
tests its status. It will exit automatically after finishing testing, LED resume.
②
When UPS is in battery mode, press and hold the self-test/mute key for more than
1 second, the buzzer stops beeping. If you press and hold the self-test/mute key for
one more second, it will restart to beep again.
4.3
Parameter setting
UPS has setting function. It can run the setting on any mode. After setting, it will
become effective at once when meets some standards. The set information can be
saved only when the battery connected and normally turning off the UPS.
The operation of setting is as following:
4.3.1
ECO mode setting(1)
①
Enter the setting interface. Press and hold the function setting key
for more
than 2 seconds, then come to setting interface, the letters “ECO” will flash
②
Enter the ECO setting interface. Press and hold the function setting key
for
more than half a second(less than 2 seconds), then come to setting interface of ECO,
at this time, the letters “ECO” will light for a long time. The “ON”(or OFF) below the
ECO will flash. Press and hold the inquiring key
for more than half a second (less
than 2 seconds) to determine whether the ECO function is used or not. If used, the
corresponding word is “ON”, if not, the word is “OFF”. It can be determined by
yourself.
