30
Kleiss MCS60-1016 System Manual v.15 June 2020
|
www.MainlineControlSystems.com
Select proper chute from the sizing table in
Section 4.0.
Unthread protective end from the bottom of the
tower.
Connect the chute into the bottom of the stopping
tower.
(There is only one way to connect the chute
properly and that is to match the pin and the
indent in the tower.)
Using the same Kleiss silicone spray you used
on the stopper, lightly spray the open end of the
chute.
Using the gear box air ratchet, drive the threaded
rods up through the gear box to completely retract
the chute into the tower.
Grease stopper rod with Kleiss silicone grease.