Operating Instructions MI 34 / MI 34 H
GEBAmi34e.11a.docx
8
850 232/14 08/11
Figure 2
Diagnostic probe
with additional
screening probe tip
3 Getting started
Your MI 34 was carefully inspected and packed for shipping. However, it is
good practice to thoroughly inspect the outside of the shipping container
for signs of damage. If any damage is noted, please notify the carrier
immediately.
3.1 Unpacking
Save all the original packing material and the shipping container so
the instrument can be properly packaged if it needs to be returned
for service or calibration.
Please check that all accessories listed below are received in good condition.
If any accessories are missing or damaged, immediately notify your MAICO
Special Instrument Distributor.
Accessories
1 Diagnostic probe
1 Screening probe insert
1 Shoulder strap for diagnostic probe
1 Contraphone with cord including
24-count eartips kit:
(4) yellow, 7 mm
(4) green, 9 mm
(4) white, 11 mm
(4) yellow, 13 mm
(4) green, 15 mm
(4) blue, 18 mm
Thermal printer paper (1 roll)
Calibration test cavity
Main cable
3.2 Connect probe
Connect the probe cable to socket
on the rear of the instrument. Insert
the plug into the socket and protect the connection by fastening the two
screws of the connector.
Insert the pressure tube into the socket
¬
♦
and press it until it has a safe fit
on the socket.
