8. Mounting ‒ Final assembly │ UK
21
3. Check position of cable grommet [9]. It
must be well sealed.
8.4 Final assembly
Before fitting the electronics cover,
check the location of the external
climate sensor's connection cable to
make sure that the mounting of the
internal climate sensor is not
blocked.
1. Insert electronics cover [7] into housing
recesses
I, II
and
III
, until the 3 locking
tabs snap into place. Press the electronics
cover firmly on to the housing at the points
indicated by the arrows.
2. Insert the supplied internal climate sensor
[6] correctly (
arrow X) in the connector
sockets.
3. Fit cover [4].
8.5 Start-up
1. Switch the mains fuse on.
2. Run function test.
3. Save reference humidity by pushing
button 1 [15].
4. Fit designer cover [3].
Saving of the reference values is
shown by LED 1 blinking.
9. Maintenance
The unit is maintenance-free.
10. Cleaning
DANGER
Danger to life from electric
shock.
Switch the mains fuse off.
NOTICE
Risk of damage to unit if
incorrect cleaning agent is
used.
Only use water to clean cover [4]
and designer cover [3]. Do not
use aggressive cleaning agents.
NOTICE
Danger of short-circuits and
damage to the unit. Humidity
will penetrate if electronics
cover is not fitted correctly.
Press electronics cover firmly
onto housing such that it is sealed
and flush all the way around.
When doing so, do not press
setting buttons [15] and [16].
Summary of Contents for AKE 150
Page 35: ...35...
