Mahr Digimar 817 CLM, Operating Instructions Manual

Page: 28 / 152

28
Mahr GmbH • Digimar 817 CLM
3.1 Start a measurement procedure with
the function keys
The function keys can be used to start different
measuring functions with one touch of a key.
The procedure is always the same:
–
Position the probe either above or below the
point that is to be measured
– Press the function key to start the measuring
function
The probe automatically travels to the surface to be
measured and accepts the measured value. When
conducting dynamic measurements, where a maximum
or a minimum (bore or shaft) is to be measured either
the workpiece or the measuring instrument must then
is moved so that the measuring instrument can
determine an extreme value. When measuring with 2
contacts (e.g. a bore, groove or shaft), the first contact
must be upwards (from below).
Function keys:
1 Contacting a surface / plane from above or
below
2 Determining the center and width of a groove
3 Determining the center and width of a ledge
4 Determining the center and diameter of a bore
5 Determining the center and diameter of a shaft
6 Measuring a bore (maximum or minimum)
7 Measuring a shaft (maximum or minimum)
1 3 2 4 6 5 7
3 Brief guide to measurement methods
Optional
3.1.1 First measurement
3.1.2 Contacting a surface from above
– Position the probe
– Press the key to start the measuring procedure
The measured value will appear in the upper section of the display