16 Series, Model - 2816 HST
18
STEP 15
For tractors with a sunshade,
STEP 12, STEP 13 and STEP 14
must be followed for using the
lock bolts. On tractors without a
sunshade, it is recommended
that STEP 12, STEP 13 and
STEP 14 be used, however, if
ROPS is folded frequently for low
clearance tractor operation, the
following setup may be used:
STEP 11
For tractors without a sunshade
and for operators who frequently
fold the ROPS for low clearance
tractor operation, continue to
STEP 15.
STEP 12
Loosen the jam nut on the lock
bolts.
STEP 13
Tighten the lock bolt only enough
to remove the looseness of the
hinge joint. Push the ROPS bar
forward to permit the position pin
to be rotated and removed by
hand.
Tighten the jam nut on the lock
bolts to a torque of 33 to 40 lb ft
(44 to 54 Nm).
STEP 16
Check the assembly. If the posi-
tion pins are too tight or loose,
repeat STEP 15.
Tighten the lock bolts to a torque
of 33 to 40 lb ft (44 to 54 Nm).
STEP 14
Tighten the jam nut on the lock
bolts to a torque of 33 to 40 lb ft
(44 to 54 Nm). Continue to STEP
17.
JAM NUT
LOCK BOLT
LOCK BOLT
LOCK BOLT
JAM NUT
LOCK BOLT
JAM NUT
LOCK BOLT
SAFETY/DECALS_______________________________________________________
